SAF FreeMile Series, Руководство пользователя

Страница: 20 / 91

The SAF FreeMile Series Full Outdoor Unit Technical Description and Configuration Guide • Rev. 1.3
© SAF Tehnika JSC 2012
20
2.2.8 Initial configuration with Web GUI
In order to perform initial configuration you will need a laptop with LAN card, 2 Category 5e Ethernet
cables and a Power over Ethernet injector.

Your connected laptop should be in the same subnet with manageable SAF FreeMile, so you can
“see” them; that is why, the laptop Ethernet port settings should be set as follows: (in ‘Microsoft
Windows’ go to Control panel

Network Connections

Local Area Connection

Properties

Internet Protocol (TCP/IP)

Properties ):
–
IP address 192.168.205.1;
–
Net mask 255.255.255.0;
–
everything else is blank.

You must have PoE (Power over Ethernet) injector with the minimum of 20W power supply to
connect the laptop to the SAF FreeMile FODU. Power over Ethernet injector can be purchased
from SAF Tehnika JSC as optional accessory.

To know IP address, side value should be read from the label. See Chapter 1.7 for details.
–
If Low Side ‐ > IP: 192.168.205.10
–
If High Side ‐ > IP: 192.168.205.11

Connect to SAF FreeMile FODU by entering IP address in the browser address line ‐ by default
192.168.205.10 for the low side and 192.168.205.11 for the high side.
(!) Default username for Web, Telnet and FTP access is admin and password is changeme.

It is recommended to use the following or later versions of web ‐ browsers:
–
IE v. 6.0
–
Mozilla Firefox v. 2.0.0.11
–
Safari v. 3.0
–
Opera v. 9.50
Initial configuration in Web GUI should be done individually for each SAF FreeMile FODU.
STEP 1
First step is to choose your antenna size (30, 60 or 90 cm) in Main page „Radio configuration”. Press
„Apply” button. Note that “Apply for local and remote” button will not operate until microwave link is
established.
STEP 2
Run „Spectrum analysis” while second unit is not transmitting in order to check availability of
required channel as well as overall interference
STEP 3
Judging upon observed interference, choose free channel in 30MHz or change channel bandwidth to
10MHz and change modem configuration if required
.
STEP 4
Activate Tx power by choosing Tx power value in Main page „Radio configuration” and pressing
„Apply” button.
STEP 5
All configuration steps should be repeated for the second SAF FreeMile unit.
If everything was configured correct, you will see a screen similar to the one in Figure 2.9. (without
alarm indications).