SAF-HOLLAND SK RB 9022 H, Руководство по обслуживанию и ремонту

Страница: 19 / 34

19
D) Installation instructions
Check for wear in the guide pins. To measure the outer guide pin
fit a magnetic holder with dial indicator onto the brake mounting.
Set the tip of the indicator on point A, and raise and lower the
brake calliper alternatively as shown in the illustration. Finally carry
out measurement of the inner guide pin behind the brake disc
several times measuring at point B. The maximum play should not
exceed
1,0 mm .
Visible check
Check protection cap and folding bellows guide pins
(2 each per guide pin).
the folding bellows and protection cap must be replaced if they
show signs of tearing or other damage.
Should work be required see page 22 – 24.
Fit the brake linings (see below).
Fitting brake linings
Note!
The brake must be completely adjusted in the back position before
fitting the linings.
Clean brake lining cavity.
Push the brake calliper in the direction of the outside of the vehicle
and fit the outer brake lining.
Push the brake calliper finally in towards the inside of the vehicle
and fit the inner brake linings, (connect wear indicator if applicable)
Fit lining retainer springs.
Fitting retainer hoop
Fit the lining retainer hoop in the brake calliper and fix with the safety
screws (20±3 Nm).
Carry out basic adjustment (see page 20).
Note!
The wheel hub must be free to be moved manually after actuating
the brake (adjust play if necessary).
A
B
20±3 Nm