18
D) Installation instructions
Bolting on the brake calliper
Position the brake calliper and screw in M 16 x 1.5 x 55 collared
bolts (tightening torque 290 Nm).
Coat ABS sensor (see arrow) all around with copper paste and install
in the sensor holder.
Push in the ABS sensor until it contacts the exciter.
Measure the output voltage at the ABS sensor cable using a volt-
meter (approx. 100 mV) while turning the brake disc or wheel
flange.
Checking the folding bellows on the pressure pins
The check is to be carried out with the brake linings removed (see
page 14).
Turn the adjuster rod using an 8 mm ring spanner until the protec-
tion spring is completely visible.
Note!
The pressure pin may only be screwed out to a max. of 50 mm!
Check the protection spring. Finally replace the protection spring
and check the folding bellows.
If the folding bellows or protection spring is torn or show signs of
other damage then they must be replaced.
Loosen the adjuster rod.
Do not tighten!
Should work be required (see page 21 - 22)
Fit the brake linings (see page 19)
Inspection
Sliding function
Check the sliding movement of the brake calliper over the guide pins.
The brake calliper must be easy to move manually.
max.
50 mm
Содержание SK RB 9022 H
Страница 4: ...NOTIZEN NOTES NOTE 4...
Страница 33: ...NOTIZEN NOTES NOTE 33...
