SAF-HOLLAND SK RB 9019 W, Руководство по обслуживанию и ремонту

Страница: 21 / 30

D) Installation instructions
21
Replacing the folding bellows of the
pressure pad!
Dismantle brake linings and pressure plate (see page 14)
Move brake calliper by hand towards the cylinder.
Pull out the protection cap 66 using a screwdriver from the brake
calliper seating.
Check the thread on the adjuster screw.
Note! Lay the rim side brake lining in the lining cavity so that the
adjuster cannot be screwed out of adjustment. After checking remove
the linings again.
Secure the adjuster screw against turning (arrow) and screw out
approx. 30 mm anti-clockwise using a ring spanner on the hexago-
nals.
During this time check the thread for damage or corrosion.
Note!
The protection cap 66 can be replaced if dirt or water is seen to be
present over the seal seat of the brake calliper, or if the protection
cap has been damaged immediately prior to servicing. Should parts
be found to be corroded then the brake should be replaced in case
of doubt.
After checking, grease the thread and partly screw the adjuster
clockwise again.
66