
If necessary, an additional connector pipe for the combustion air (special attachment) can be attached
to
the rear of the wood-burning stove, so that the combustion air will not be supplied centrally. To do this,
the radiation plate must first be loosened from its 4 anchor points. In addition, the cotter pin must be
removed from the air inlet shaft at the bottom, so that the shaft and the handle can be dismantled.
Once
these sections have been removed, the combustion air connector pipe and the seal can be screwed
down on the rear. Now you should manually slide the air inlet completely to the right (rear view/position
“0”), and attach the handle again; set it to position “0” (left rib lining). Finally, rotate the shaft through
the
side opening of the combustion air connector pipe until the short corner fits into the bottom opening of
the air inlet handle again. Replace the cotter pin and attach the radiation plate on the rear. The
combustion air can now be supplied directly via an Aluflex pipe (100mm diameter).
11. WARNING! PLAYING CHILDREN!
A stove gets hot! Particularly the cover plate, the protective
casing and the glass.
You should therefore ascertain that there are no playing
children in the area before lighting the stove.
The safety measures cannot rule out the possibility of
accidents completely.
KEEP SMALL CHILDREN AWAY FROM THE VICINITY OF THE STOVE AS MUCH AS POSSIBLE!
12. Kindling
Set the air inlet to maximum for the lighting of the stove.
Through the filler door opening, spread out a broad layer of small kindling-wood on the floor of the
combustion chamber. Now lay the required quantity of firewood on top. Place a thin layer of firewood
op top
of this, and then a bit of splintery wood.
Use about 3 matches to light all the wood. We suggest the following: one match at the back and two at
the
front. This will ensure that everything ignites well.
You could also use 4-5 firelighters. Now add a small quantity of fuel. Close the door firmly after the fire
has
been lit.
55
13. Stoking up of the fire with wood
– Firewood
(The appliance can also be filled via a side door!)
To ensure that the appliance rapidly reaches the desired temperature so that the release of harmful