Saeco RI9722/11, Руководство по обслуживанию

Страница: 62 / 224

5. SERVICE PROGRAMME INCANTO S-CLASS
Page 10/18 REV.1 FEB.2005 Saeco International Group
Function/Standard Setting range Increment Comments
----HEATING----
SENSOR ADJUST.
96
To adjust processor tolerances.
If the temperature in test mode with a
set measuring resistance of 3246
Ω
exceeds or falls short of the specified
temperature value (96
° C) by more
than 1 ° C, the value indicated in test
mode must be applied to adjust the
sensor.
No measuring resistance: Do not
change!
NORMAL TEMP.
° C 90 70- 130°C +/- 1 Normal temperature is used if not
more than 6 min. have elapsed since
last coffee dispensed.
HIGH TEMP.
° C 111 70- 130°C +/- 1 If no coffee is dispensed for an
extended time (over 6 min.), the next
coffee will be heated to a higher
temperature to compensate for
cooling of the brewing unit and the
associated temperature loss.
TEMP. OF 1st
COFFEE
° C 118 70- 130°C +/- 1 Used when dispensing the first
coffee after the machine has been
turned on, to compensate for the high
temperature loss due to the cold
brewing unit and water pipes.
STEAM TEMP.
° C 125 70- 135°C +/-1 No function
TEMP. INCREASE
° C 0 0-50°C +/-1 The boiler temperature is increased
by a set value shortly before brewing
in order to pre-heat the boiler and
compensate for the temperature drop
during the first water flow.
GRINDS COUNTER
Number 0-50 +/-1 Counts number of coffee cycles.
When this value reaches the Grinds
Stop value, "GRINDS CONTAINER
EMPTY" will be displayed. (Reset
by removing dregs drawer for
emptying - min. 6 sec.)
GRINDS STOP
12 5-50 +/-1 Number of cycles until "EMPTY
GRINDS CONTAINER" is
displayed.
TOTAL WATER
(ml) Number Total water flow volume (in ml) / not
resettable
WATER DESCALING
(ml) Total water flow (in ml) since last
descaling / resettable
WATER FILTER
(ml) Number 0 - 999999999 +/- 1 Total water flow (in ml) since last
filter reset (60,000 - replace filter)