Saeco CRISTALLO 600, Использование и обслуживание

Страница: 11 / 64

11
English
Fig. 6
3 SAFETY
3.1 Introduction
In compliance with the Low Tension Directive 2006/95/
EC (which replaces the directive 73/23/EEC and following
amendments) and CE Marking Directive 93/68/EEC,
SAECO Vending has drawn up a technical file of the
CRISTALLO 400 e CRISTALLO 600 vending machine held
at its plants. The following regulations were taken into account
during the design phase:
- EN 55014 - EN 6100-3-2
- EN 61000-3-3 - EN 61000-4-2
- EN 61000-4-3 - EN 61000-4-4
- EN 61000-4-5 - EN 61000-4-11
- EN 60335-2-75 - EN 60335-1
3.2 General safety regulations
It is forbidden to:
- tamper with or disable the safety systems installed on the
vending machine;
- carry out maintenance on the vending machine without
unplugging it first;
- install the vending machine outdoors. It should be placed
in dry areas where the temperature never falls below
1°C;
- use the vending machine for purposes other than those
indicated in the sale contract and in this publication;
- connect the appliance to the mains using multi-sockets
or adapters;
- use water jets to clean the vending machine (Fig. 6).
It is compulsory to:
- check the electrical power line for conformity;
- use original spare parts;
- read the instructions contained in this publication and in
the enclosed documents carefully;
- use personal protection devices during installation, testing
and maintenance operations.
Precautions for preventing human errors:
- make the operators aware of safety issues;
- handle the vending machine, either packaged or
unpackaged, in safe conditions;
- have a thorough knowledge of the installation
procedures, its operation and limits;
- dismantle the vending machine in safe conditions, in
accordance with the environmental protection and health
and safety laws in force.
Warning
In case of failure or malfunctioning contact only qualified
CUSTOMER SERVICE personnel.
Important
The Manufacturer declines any liability for any damage caused
to property or injury caused to persons as a result of failure
to observe the safety regulations described here.
3.3 Operators’ requirements
Three operators with different skills are required in order to
guarantee the safety of the vending machine:
User
Access to the internal part of the vending machine is forbidden
to the user.
Supply operator
The Maintenance Technician assigns the safekeeping of the
access key to the Supply operator who is in charge of product
supply, external cleaning, and starting up / stopping of the
vending machine.
Warning
The Supply Operator is not authorized to carry out operations
which are indicated as being the duties of the Maintenance
Technician in this publication.
Maintenance Technician
The Maintenance Technician is the only person authorized to
intervene and start programming procedures, and perform
adjusting, setting up and maintenance operations on the
vending machine.