Saeco CRISTALLO 600, Использование и обслуживание

Страница: 41 / 64

41
English
• Beverage check
Enables brewing tests to be carried out on the beverage
just set.
By pressing
ENTER
the message “PRESS KEY” is
displayed and it is possible to choose the key to be
pressed, relative to the type of brewing test:
- A key Full beverage;
- B key Beverage without cup, sugar and stirrer;
- C key Water only;
- D key Powder only.
Important
If the sequence includes several instant products, the sequence
“INSTANT PRODUCT - WATER - DELAY - INSTANT
PRODUCTS - % OF INSTANT PRODUCT” will be shown
again.
If the setting relative to the instant product (“INSTANT
PRODUCT - WATER - % INSTANT PRODUCT”) means that
the powder dispensing lasts longer than the water dispensing,
the vending machine stops powder dosing (to avoid insufficient
rinsing of the mixer) and emits a beep. Check the settings
again to obtain correct dispensing (powder dispensing must
end a few instants before the water dispensing is complete,
to allow good rinsing of the mixer).
• H2O / Coffee
This defines the quantity of coffee to be brewed.
Example: “38” indicates that 38 water units will be
brewed. The reference unit is preset by the manufacturer.
The quantity of dispensable coffee can be adjusted from
“0” to “500” in steps of 2.
• Sugar
This defines the quantity of sugar to be dispensed with
the beverage.
The following table shows the result of the various settings.
• H2O / Soluble
It defines the amount of water to be mixed with the instant
powder.
Example: “3” indicates that water will be mixed with the
instant product 3. “022” indicates that 22 water units
will be brewed with the instant product. The reference
unit is preset by the manufacturer. The amount of water
can be adjusted from ‘“0” to “500” in steps of 2.
• Motor delay
This option enables entry of a programmable start delay
on instant product motors.
• % Instant product
This defines the speed at which the instant powder and
water are brewed (see chart).
Brewing speed of instant powder and hot water is
adjustable from “10” to “120” in steps of 10.
By setting a value of “10”, the pump works at the
maximum capacity, while the instant product is brewed
with impulses, at minimum capacity. Setting “100” both
the instant product and water will be brewed at maximum
capacity.
Setting “120” the pump works, with impulses at minimum
capacity, while the instant product is brewed at maximum
capacity.
Sugar in beverage
without preselection
Without
1
2
3
4
Without
Settings
0
1
2
3
4
NO
Sugar in beverage
with preselection
Quantity preselected
Quantity preselected
Quantity preselected
Quantity preselected
Quantity preselected
Without sugar
BEVERAGE 01
H2O/COFFEE 080
BEVERAGE 01
SUGAR 0
BEVERAGE 01
BEVERAGE CHECK
BEVERAGE BREWING BEVERAGE BREWING
BEVERAGE 01
CONTINUES
BEVERAGE 01
%INSTANT PROD.3:022
BEVERAGE 01
INST.PR.Delay03:005
BEVERAGE 01
H2O/SOLUBLE 03:005
Fig. 60
Pump
speed
MAX
MIN
10 100 120
% Soluble
Soluble
speed
MAX
MIN
10 100 120
% Soluble