SAC SE SERIES, Инструкция по установке и настройке

Страница: 78 / 149

SOUTHERN AVIONICS COMPANY
SE Series Installation and Setup 6-2 System Site Configuration
NOTE: Normally the ATU switch should be in the ON position. If the ATU switch is off, the SE
system will show the ATU message (shown below) automatically on the main menu.
The dual or single transmitter system will be defined in the upper left hand side of the screen
following “SE SERIES” (see Main Menu above). If any faults exist, they will be shown in the
upper right hand side of the screen. Additional display screens are chosen by using the UP and
DOWN keys to more menus which show the overall / transmitter data.
The dual system also utilizes the following four keys:
•
LCD DATA - to choose TX1 or TX2 display and control.
•
TEST MODE - to allow both transmitters to operate simuitaniously for testing purposes.
•
MAIN TX - to allow primary/secondary assignment monitor.
•
MONIOTR (system status: PRI, SEC, FAIL) - to enable or disable monitoring usually for
testing purposes.
Use the UP key to cancel or go the previous menu anytime.
6.2 Primary Transmitter Selection
LCD DISPLAY
Use the MAIN TX key to change TX1 <->TX2 as primary transmitter.
Example: Press the MAIN TX key to change to TX2. The TX2 green indicator will illuminate and
the TX1 indicator will extinguish.
WEB WATCH
In the SE SERIES TRANSMITTER Web Watch window, click on the Primary TX from the right column box
on the Main window to open the Primary Transmitter window, shown in
Figure 6-1.
********* ATU SWITCH IS OFF **********
Please check hardware.