SAC SE SERIES, Инструкция по установке и настройке

Страница: 141 / 149

SOUTHERN AVIONICS COMPANY
SD Series Installation and Setup 11-1 Closing Up The System
11 Closing Up The System
11.1 Reinstalling/Closing Panels
11.1.1
Reinstall the Power Control Panel and lower transmitter drawers, while ensuring none of the
wiring is pinched or kinked. Fasten the drawer with the mounting screws removed in step 3.1.1
on page 3-1.
11.1.2
Reinstall the transmitter enclosure’s front panel that was removed in Step 1.3. Ensure the
panel’s fastening screws are torqued sufficiently to seal the enclosure against water and dust
ingress without crushing or deforming the sealing gasket. Begin by starting all screws and then
tighten sequentially from the center outward in steps. The gasket should be uniformly
compressed to approximately one half of its original thickness.
11.1.3
Reinstall the Coupler’s coil access panel that was removed in Step 9.1.1.
11.1.4
Reinstall/close the Coupler enclosure’s front panel that was removed/opened in Step 9.1.2.
Ensure that the screws are torqued sufficiently to seal the enclosure against water and dust
ingress without crushing or deforming the sealing gasket. Begin by starting all screws and then
tighten sequentially from the center outward in steps. The gasket should be uniformly
compressed to approximately one half of its original thickness.
11.2 Conduit Sealing
For an exterior mounted transmitter, seal any open conduits at the bottom of the transmitter’s
enclosure with a silicone sealant to preserve its ingress protection rating.
11.3 Optional RF Weatherproofing
11.3.1
Apply two wraps of electrical tape over the Type N RF connections on both the Transmitter (if
exterior mounted) and the Coupler.