SAC MAXI-MIXER 4700 TRAILER, Руководство оператора

Страница: 18 / 56

Page # 18
877 1st Ave. N.W. | Sioux Center, IA 51250 | Toll Free: 1.866.722.1488 | siouxautomation.com
OPERATION
REPLACEMENT PARTS
READ complete manual CAREFULLY
BEFORE attempting operation.
• Wheel Bolts must be kept properly torqued. Damage to the rim may occur if wheel bolts are not checked frequently.
8-bolt rim: 170 ft lbs-Grade 8 Lug
10-bolt rim: 300 ft lbs-Grade 8 Lug
• Tire Wear and Pressure must be checked to ensure that there is no excessive wear, and that tires are inflated to the rec-
ommended operating pressure for each given tire.
• Rain can accumulate in mixer if stored outside, always remove drain plugs on hopper ends to allow unit to drain completely
and replace drain plugs before next use.
• Freezing Weather the PTO shield requires extra grease to prevent freezing. Snow can accumulate in mixer if stored outside,
always remove drain plugs on hopper ends to allow unit to drain completely and check hopper for snow or ice buildup
before operating unit. Thaw and remove any obstruction and replace drain plugs before next use.
IMPORTANT: WHEN WELDING ON THIS UNIT: Do NOT allow the current to flow through the bearings, roller chains, or scale
weigh bars. Ground directly to the item being welded. ALWAYS disconnect weigh bar cords from scale indicator before welding.
INSPECT AND ADJUST
• Scale Indicator: Refer to the electronic scale operators manual for adjustment information. The operator’s manual
for the Electroic Scales should be kept with this manual. Additional scale manuals may be obtained through Sioux
Automation Center, Inc.
• Load Cells: Should be kept clean, dry,and lubricated to insure dependabiltiy.
• Normal Scale Activity: Some warm up scale “drift” may occur after the scale is turned on but should zero balance within
10-15 minutes. Scale may zero shift over night due to temperature changes.
ELECTRONIC SCALES
MIXER OPERATION