Sabre 1338 Gear, Техническое руководство

Страница: 83 / 191

GEAR POWER TRAIN
REPAIR
5 - 32
2/12/97
9. Measure air gaps (K and N)—(see Inspect Drive/
Intermediate Shaft Assemblies). Make any
changes in shim washer (M) thicknesses from
Shim Kit and shim washer (J) thicknesses from
Shim Kit to obtain proper air gaps.
10. When proper air gap is obtained, gears should drag
slightly against feeler gauge.
11. Apply Never-Seez® to top surface (O) of shifter
plate and contact portions of shifter shaft (P) and
(Q) with upper and lower case halves.
12. Install shifter fork assembly.
Assemble Idler Combination Gear Assembly:
1. Install components on idler shaft in order shown:
N
K
J
M
L
O
P
Q
A
B
C
D
E
F G
• Washers (A and C) should be 0.632 x 1.00 x 0.026
in.,
• Spacer (B) should be 0.630 x 1.00 x 0.169 in.,
• Narrow combination gear (D) should have 35 good
teeth and wide combination gear (E) should have
12 good teeth,
• Idler shaft (F) should be smooth, not scored, worn,
or pitted,
• Shim washer(s) (G) are found in Shim Kit.
2. Install idler combination gear assembly (H) into
lower case half.
3. Measure air gap (J) between shim washer (I) and
face of case (K) (see Inspect Idler Combination
Gear Assembly).
4. When proper air gap is obtained, assembly should
drag slightly against feeler gauge.
Assembly Transaxle Housing Case Halves:
I
J
K
H
Upper Case
Half
Lower Case
Half
www.servicemanualall.com