Sabre 1338 Gear, Техническое руководство

Страница: 139 / 191

HYDROSTATIC POWER TRAIN
REPAIR
6 - 54
2/12/97
IMPORTANT: When assembling case halves make
sure that bypass push pins are fully seated in
bore and that actuating bracket and rod are fully
withdrawn. Failure to do so will result in broken
push pins.
3. Align hole (C) with bleed port stack (A) and firmly
push lower case half onto upper case half.
4. Align all 17 case halves holes.
5. Install 17 cap screws (E) finger tight initially and then
tighten from center-to-outside in a crossing pattern,
beginning with two cap screws (G). Tighten 17 cap
screws to specifications.
Specifications:
New upper case . . . . . . . . . . . . . . . 30 N•m (22 lb-ft.)
Used upper case . . . . . . . . . . . . . . 27 N•m (20 lb-ft.)
6. Install new o-ring on drain plug (F) and tighten it to
24 N•m (17 lb-ft.).
Install Brake Assembly—
F
G
E
B
1. Install brake components to transaxle and, using
friction puck shims (B), adjust air gap (C) between
brake lever and brake disc to 0.8—1.3 mm
(0.030—0.050 in.).
2. Tighten cap screws (A) to 55 N•m ( 40 lb-ft.).
Install Reservoir Cover and Breather Valve
Assembly and Fill Reservoir—
1. If reservoir cover was removed or replaced, apply a
solid bead (A) of Form-In-Place Silicone Gasket
Sealant around the cover, staying to inside of holes.
2. Install cover to reservoir and fasten with 4 cap
screws (C). Tighten cap screws to specification.
3. Fill reservoir with 1.6 L (1.7 U.S. qt) of 10W30,
Class-CD engine oil. Oil should reach bottom of fill
hole (D).
A
B
C
A
C
B
E
D
www.servicemanualall.com