Assembly and operating manual
rtv.sabaj.pl/en/home/
a)
To s
et the VP follow this
procedure:
•
Press & hold the SETUP button for about 2 seconds, until the red SETUP light is lit
and you hear 2 short “beep” sounds. You are now in the programming mode.
•
Press the DOWN button to set the preferred position.
•
When you have set your preferred position, press RC
-
SET button (you will hear
repeated "beep" sounds). Press the DOWN button on the remote or control box. You
will see this symbol on the display
•
Press the UP button to set the preferred position.
•
When you have set your preferred position,
press & hold RC
-
SET button (you will
hear repeated "beep" sounds). Press the UP button on the remote or control box.
You will see this
symbol on the display
•
Press & hold SETUP button for about 2 seconds, until the red SETUP light is off and
you hear
2
short “beep” sounds. The viewing position is now set
11.
RF Remote Control assignment:
The supplied RF remote is already programmed with your
T
V
-
Lift. In
case you want to
program a new one, follow these steps:
•
Press the RC
-
SET button. You will see this symbol on the display
•
The lift will wait for any signal from a remote for 15 seconds from now on
.
•
Press any button on your remote
.
•
The lift will acknowledge the new remote , which will now be operative
.
NOTE:
Pressing and holding RC
-
SET bu
t
ton for 5 seconds removes all assigned RF remotes
.
12.
POWER GUARD (Standby mode detection):
lf you will plug your lV in to The control box
socket
-
it will monitor the energy consumption of your screen. lf the user attempts to hide
the fully operating screen (turned ON), the
control box cuts the power out. After lifting the
screen back to the viewing position, the power will be restored to it.
lf the lV is turned
off or in standby mode, the power will not be cut out.
.
13.
Active RJ-45 Socket:
Your Premium Control box is equipped with the active RJ
-45
Socket, which allows to plug additional accessories supplied by SABAJGROUP.
NOTE
: Only the original SABAJGORUP accessories will work with your Premium Control Box. lf
you attempt to modify or connect any other devices via the
RJ
-
45 Port, you might damage the
Control Box and you will lose
the warranty for doing so
.
