Problem
Possible Causes
Solutions
Water not
pumped from
dishwasher
Kink in drain hose
Check drain hose�
Filter clogged
Check the filters (see “Cleaning the Filter Unit”)�
Kitchen sink clogged
Check kitchen sink to make sure it is draining
well� If kitchen sink is not draining, you may ask a
plumber to check it�
Suds in the tub
Improper detergent
Use only the detergent special for dishwasher to
avoid suds� If this occurs, open the door and let
the suds evaporate� Close the door securely then
start the soak wash cycle to drain the water out�
Repeat if necessary�
Spilled rinse aid
Always wipe up rinse aid spills immediately�
Stained tub
interior
Detergent with colourant
is used�
Make sure the detergent does not contain any
colourant�
White film over
the inside surface
Hard water minerals
To clean the interior, use a damp sponge with
dishwasher detergent and wear rubber gloves�
Never use any other cleaner than dishwasher
detergent for the risk of foaming or suds�
There are rust
stains on the
cutlery�
The cutlery is not
corrosion resistant�
No programme has run
after dishwasher salt was
added�
Traces of salt have got into
the wash cycle�
Always run the rapid washing programme�
Add dishwasher salt with no crockery in the
dishwasher�
The dishwasher
is noisy�
Dishes are rattling against
each other�
The spray arm is knocking
against the dishes�
Refer to “Loading the Basket” to rearrange the
dishes�
Problem
Possible Causes
Solutions
The dishes are
not clean�
The dishes have not been
arranged properly�
Refer to “Loading the Baskets”�
The washing programme
selected is too gentle�
Select a more intensive programme� Refer to
“Washing Programmes”�
Not enough detergent
has been used or it is
unsuitable�
Use more detergent or change the detergent�
The spray arms are
clogged�
Rearrange the items so that the spray arms can
rotate freely
The filters are not clean or
not in the correct position�
Clean and/or position the filters correctly�
Streaking and
straining on the
dishes
The rinse aid dispenser
setting is not high
enough�
Adjust the rinse aid dispenser setting�
The dishes are
not quite dry�
Improper loading
Refer to “Loading the Baskets”�
The rinse aid has run out
or too little is being used�
Increase or refill the amount of rinse aid�
Wrong programme
selection
Choose a programme with long washing time�
Error codes
Error codes
Meaning
E1
Door is not closed�
E2
Water inlet malfunction
E3
Drainage malfunction
E4
Temperature sensor malfunction
E5
Overflow/leakage
E6
Water leakage
E7
Abnormal heating
45
44
GB
GB
