Programme
Degree of soil
Cycle Description
Recommended
quantity of
detergent
pre-wash /
main wash
Washing
time
(min.)
Energy
(Kwh)
Water
(L)
Rinse
Aid
needed?
Rapid
A shorter wash
for lightly soiled
loads and quick
wash
Main wash
(40°C)
Hot rinse
15 g
39
0�50
7
No
Pre-rinse
To rinse out
loosen soil
particles from
the dishes
Pre-wash
NA
11
0�01
4
NA
* Testing programme for EN 50242
The information for comparability test in accordance with EN 50242 is as follows:
•
Capacity: 12 settings
•
Position of upper basket: Low position
•
Rinse aid setting: 5
NOTE:
1� The washing time may vary depending on the incoming water temperature and the ambient
temperature�
2� The power consumption in left-on mode is 0�9W (door open), in off-mode it is 0�1W�
1� Turn the water tap on�
2� Open the dishwasher door�
3� Check the filters�
• Ensure they are clean and properly positioned. See “Cleaning and maintenance” section.
4� Check that there is rinse aid and salt�
5� Load the dishes�
• Ensure that the spray arms can rotate freely.
6� Add the required amount of detergent into the dispenser according to the “Washing
Programmes” chart�
7� Close the dishwasher door securely�
8� Press to switch on the dishwasher�
• The Eco programme indicator light will flash and the washing time will illuminate on the display.
Starting the Dishwasher
9� Select the desired washing programme by repeatedly pressing
• The corresponding washing programme indicator light will flash.
•
Delay timer:
The delay timer allows you to delay the start of a washing programme
from 1 hour to a maximum of 19 hours�
Repeatedly press
until the desired start delay time flashes on the display,
e�g� 3H for a 3-hour delay�
Once the delay timer has been set, press
to activate the function� The corresponding
start delay time will stop flashing�
10� Start the washing programme by pressing
�
• The selected programme indicator light will stop flashing.
11� At the end of the washing programme, the dishwasher will buzz and automatically stop�
12� Wait for about 15 minutes before you open the dishwasher door in order to avoid burns�
13� Unload the dishes�
The washing cycle will not start if the dishwasher door is left open or not properly closed�
Do not open the door when the dishwasher is working since hot water may be ejected,
which could cause scalding�
Adding extra crockery
1� Without switching off the appliance, press
to pause�
2� Open the door, taking care to avoid the escaping steam�
3� Place the crockery inside the dishwasher�
4� Close the door and press
� The cycle will start from the point at which it was
interrupted�
Modifying a washing programme in progress
If a mistake was made during the washing programme selection process it is possible to change the
programme�
1� Press to turn off the appliance and then press again to turn it on�
2� Repeatedly press
to select a new programme�
• The new programme indicator light will flash.
3� Press
to start the programme�
Child lock function
The child lock function is designed to prevent children from operating the dishwasher�
To activate this function:
Press and hold
for about 3 seconds until a beep is heard�
The text “LO” and the current programme washing time will briefly flash alternately� This function can
only be activated when the machine is in operation�
41
40
GB
GB
