Control Panel
1� Power button
2� Delayed start button
3� Washing programme/child lock button
4� Start/Pause button
5� Refill salt indicator light
6� Refill rinse aid indicator light
7� Display
• To show the washing time, delayed start
time or error codes�
8� Washing programme indicator lights
Overview
Intensive
Light
Crystal
Rapid
Pre-rinse
Before installing your dishwasher
Installation instructions
Before connecting your dishwasher to the power supply, check that the voltage stated on the rating
label of your appliance corresponds to the voltage in your home�
The appliance must be grounded� The manufacturer is not responsible for damages that may occur as
a result of usage without grounding�
WARNING:
Disconnect electrical power before installing your dishwasher�
Your dishwasher can be installed in various locations in your kitchen as long as there is space and
accessibility to connect your dishwasher to the water/drainage and electrical supply�
Do not connect an extension lead to the appliance to avoid potential safety hazards�
For best operating results, incoming water pressure should be between 0�04 MPa and 1MPa�
Incoming water supply for the dishwasher is controlled by a ‘pressure switch’, so if the household
water pressure is low, dishwasher fill time will increase or may not operate�
WARNING:
Please close the hydrant after using�
Inlet hose (Cold water supply)
Connecting to the Mains Water Supply
Water Pressure
The water inlet hose from the machine terminates in a 3/4”
female connector� The water supply should therefore terminate
in a similar male connector and should have a stopcock close by
in the pipe�
Connect the straight connector of the inlet hose to the water
supply securely ensuring that the washers are securely in place
at both ends of the hose�
31
30
GB
GB
