About the safety supply hose
The safety supply hose consists of the double walls. The hose’s
system guarantees its intervention by blocking the flow of water
in case of the supply hose breaking and when the air space
between the supply hose itself and the outer corrugated hose is
full of water.
WARNING
A hose that attaches to a sink spray can burst if it is installed on
the same water line as the dishwasher. If your sink has one, it
is recommended that the hose be disconnected and the hole
plugged.
How to connect the safety supply hose
1. Pull the safety supply hoses completely out from storage
compartment located at rear of dishwasher.
2. Tighter the screws of the safety supply hose to the faucet with
thread 3/4inch.
3. Turn water fully on before starting the dishwasher.
How to disconnect the safety supply hose
1. Turn off the water.
2. Unscrew the safety supply hose from the faucet.
Connection Of Drain Hoses
Insert the drain hose into a drain pipe with a minimum diameter
of 4 cm, or let it run into the sink, making sure to avoid bending
or crimping it. The height of drain pipe must be less than
1000mm. The free end of the hose must not be immersed in
water to avoid the back flow of it.
89
GB
