700-8000
September - 2010
5
UNPACKING & ASSEMBLY INSTRUCTIONS
REFER TO THE DIAGRAM (below) FOR PARTS IDENTIFICATION.
READ THESE INSTRUCTIONS IN THEIR ENTIRETY BEFORE BEGINNING INSTALLATION
Prior to opening the shipping carton, carefully inspect the external condition of the shipping
materials for any visible damage. It is important that any damage be noted on the Bill of Lading
prior to signing for the delivery. Contact either S.R. Smith or your dealer immediately to notify us
of any damage or missing parts.
The MAC is shipped in a single box and some
assembly is required. The tools required for
assembly include:
3/4” Socket
3/4” Wrench
5/16” Socket
5mm Allen Head Screwdriver
Unpacking & Assembly Procedure for the MAC:
1. Carefully open box.
2. Remove Seat Assembly (2), Frame Assembly (1), and Seat Pad (13) for attachment.
3. Open hardware package and separate into groups.
4. Remove Manual Wheels (3) from box.
5. Attach the two Manual Wheels to Base Assembly using the following hardware and assembly
procedure - Qty. 2 ea. ½”-13 x 6” Hex Head Bolt (7), Qty. 4 ea. ½” Flat Washer (8), Qty. 6 ea. ½” Nylon
Washer (9), Qty 4 ea. Bushing (10) and Qty. 2 ea. ½” Lock Nut (11). Place the Frame Assembly on one
side. Thread the hex head bolt (7) through one flat washer (8) and one nylon washer (9) then through the
Manual Wheel (3) (so that the grip handles are facing away from the frame) and through one nylon
washer (9), one bushing (10) and through the Wheel Support on the Frame Assembly. Then slide one
bushing (10), one nylon washer (9) and one flat washer (8) onto the hex head bolt (7) securing the entire
assembly with one lock nut (11). Tighten the lock nut using the ¾” socket and ¾” wrench. Repeat the
process for the other Manual Wheel.
6. With the MAC resting upright on its wheels make sure both brakes function properly. The brakes are
mounted at the factory. Make sure both brakes are located so that they fully restrict movement of the
Manual Wheels when applied. If required, the brakes can be adjusted using a 5mm Allen wrench – loosen
the two mounting screws and reposition the brake assembly so that when the brakes are fully engaged
they fully restrict movement of both Manual Wheels.
