INSTALLATION MANUAL
EDGE DIVING SYSTEM
7
srsmith.com
FIG. B – EDGE DIVING BOARD
TABLE 4 – BOARD DIMENSIONS AND FULCRUM SETTINGS
Model #
Nominal Length
A
B
C
D
F
DIA.
EDGE 6
6’
70.25”
17.25”
6.31”
4.00”
42.50”
.625”
EDGE 8
8’
94.00”
17.25”
6.31”
9.00”
42.50”
.625”
Jig Type
A
B
C
BOLT
Edge Fiberglass
12”
12”
6”
1/2” X 6”
FIG. C – EDGE JIG
INSTALLATION INSTRUCTIONS:
Edge Diving System WITHOUT Board Fall Unit
Be sure the concrete deck surrounding the anchor jig complies with the minimum dimensions as shown in Figure A on
pages 6.
CHECK YOUR LOCAL ELECTRICAL CODE FOR BONDING REQUIREMENTS.
Read and understand the ANSI/APSP/ICC-5 2011 American National Standard for Residential Inground swimming Pools
and Table 1 and Table 2 on page 5 before you install Edge Fiberglass Stand and/or Edge Diving Board.
The Edge four-bolt jig should be set in accordance with Table 3 on page 6. The diving board must be placed on the deep
end of the pool on centerline.
The tip of the diving board must be positioned directly over Pt. A as shown on page 5 and according to the ANSI/APSP/
ICC-5 2011 Standard and S.R.Smith’s Residential Pool Minimum Specifications.
Make sure the jig anchor bolts project out of the concrete deck 1-1/2” for the Edge Stand with ample concrete depth
below the jig in accordance with Figure A on page 6. Do not install the Edge Diving System if the deck does not meet
the minimum requirements.
TABLE 5 – JIG DIMENSIONS
