INSTALLATION MANUAL
EDGE DIVING SYSTEM
4
srsmith.com
The specifications found on page 5 of this manual represent the minimum water envelope required by S.R.Smith and
by the ANSI/APSP/ICC-5 2011 Standard for residential Inground Swimming Pools. Each of these dimensions must be
met or exceeded. Installation of a diving board of any type on a pool that does not meet or exceed each of the min-
imum specifications as provided on page 5 including but not limited to the slope requirement, is in direct violation of this
manufacturer’s instructions and the 2011 Standard, and can result in serious injury or death.
Installation of this Edge Fiberglass Stand and Edge Diving Board is limited to Residential Inground Pools ONLY.
CHECK YOUR LOCAL ELECTRICAL CODE FOR BONDING REQUIREMENTS.
There is only one Edge Fiberglass Stand and only one Edge Composite Spring Set. You can install either a 6’ or 8’
Edge diving board on this assembly in accordance with Table 1- Minimum Water Envelope ANSI/APSP/ICC-5 2011
and Table 2- S.R.Smith Residential Pool Minimum Specifications on page 5. Installing any diving board greater than 8’
on any Edge Stand is strictly prohibited.
USE ANTI-SEIZE ON ALL HARDWARE.
S.R.Smith Edge Diving Boards are designed for use only with the Edge Diving Stand and Edge Composite Spring Set.
Edge components are only compatible with other Edge components.
Comply with local government regulations for Residential Inground Swimming Pools if they exceed the ANSI/APSP/
ICC-5 2011 Standard for Residential Inground Swimming Pools.
DO NOT USE ANY EDGE DIVING COMPONENTS WITH NON-EDGE COMPONENTS!
Read carefully pages 12–15 of this installation manual which contain portions of the ANSI/APSP/ICC-5 2011 Standard
for Residential Inground Swimming Pools, ensure that you understand the minimum required diving water envelope in
Figure 3 and Table 1 provided in the ANSI/APSP/ICC-5 2011 Standard.
NOTE: The installation of this Edge Diving Stand/Edge Diving Board is not complete until you, the installer have measured
the pool as well as the diving board’s overhang, height above water and the fulcrum distance to ensure they meet the
S.R.Smith’s Residential Pool Minimum Specifications and the ANSI/APSP/ICC-5 2011 Standard for Residential Inground
Swimming Pools. In addition; the installation of this diving board is not complete until you the installer have delivered to your
customer and reviewed with your customer the “Owners Manual” as well as the “Plan Your Dive Steer-Up” brochure.
THE EDGE DIVING SYSTEM IS A JUMP BOARD
ONLY ONE PERSON AT A TIME ON THE DIVING BOARD,
WITH A MAXIMUM WEIGHT LIMIT OF 300 LBS.
IMPORTANT NOTICES
TO THE INSTALLER
