background image

 

5

 

INSTALLED SLIDES’ STRUCTURAL & INSTALLATION CHECKLIST 

 
After installation and prior to the first use of the AquaBlast

TM

 & RocketRide

TM

 Funslide

TM 

 

and periodically thereafter the owner must: 
 
     1.   Inspect the runway for visible cracks or tears. 

2.  Inspect the slide for sharp edges, protrusions, cracks or tears. 
3.  Inspect all attachment flanges for loose or corroded fasteners. 
4.  For the RocketRide

TM

 Slide, inspect all ladder tread or step-attachment points for 

evidence of shear, bending yield, or fatigue in the ladder steps, rails, or 
attachments means.  Yield is evidenced by crystallization or fine cracking of the 
ladder tread and/or surface. 

5.  Inspect the ladder handrails for rigidity and attachment.  (Can they be pulled out 

of their sockets?) 

6.  Measure the following dimensions and compare with the Manufacturer’s 

Placement Instructions on pages 3 and 4.   

  Measure the depth of water in front of the slide exit.  (4-1/2’ min. depth 4-

1/2’ from exit end of slide.) 

  Measure the height of the slide runway exit above the water. (20” max.) 

  Measure the distance between the slide centerline and the edge of other 

pool equipment. 

7.  Observe the position of the exit of the slide as shown in FIGURES M, N, O, and 

P on pages 3 and 4. 

 

INTENDED USE INSTRUCTIONS 

 
 

 

* * IMPORTANT * * 

 

READ AND FOLLOW THE SIMPLE SAFETY RULES BELOW.   

 

MAKE SURE THAT EVERYONE WHO USES THE AQUABLAST

TM

 / ROCKETRIDE

TM

 

FUNSLIDE

TM

 KNOWS AND FOLLOWS THESE RULES. 

 

ENFORCE THESE RULES WITH ADULT SUPERVISION 

 

 
 
Installed and used properly, the AquaBlast

TM

 & RocketRide

TM

 FunSlide

TM

 will give you, 

your family, friends and guests many hours of enjoyment.  Like any other piece of 
equipment however, the AquaBlast

TM

 & RocketRide

TM

 FunSlide

TM

 can be misused in 

such a way as to cause the user injury, even serious and crippling injury.  As the owner 
of a AquaBlast

TM

 & RocketRide

TM

 FunSlide

TM

  it is your responsibility to do the following: 

 

1.  Only one person allowed on the slide at any given time. 
2.  Roughhousing or horseplay on the slide is strictly forbidden. 
3.  Do not use the slide as a diving platform.  The slide is made for sliding only, not 

diving. 

4.  Before sliding, always be sure that the water lubrication is turned on. 

Содержание AQUABLAST









Отзывы: