Page 36 / 60
www.sise-plastics.com
MoldScan state:
This special test state is initiated only from its dedicated page and is displayed with the following icon:
•
MoldScan: The system is testing the previously selected zones one by one.
3.2.1.2)
S
etting the operating mode
By default, on power-up, the system is in the "Stop" state.
However, it can be set di
ff
erently:
in the "Control" view, on the "Temperature control settings" page, the "Start-up mode on power-up" can
be set. You can choose "Stop", "Standby" or "Production".
The mode at power-up will also depend on the mode of the of the system when it was turned o
ff
.
mode before
switching o
ff
set mode
System mode at start-up depending on the mode before switching o
ff
and the set mode.
3.2.1.3)
C
hanging the system mode
The system mode can be changed through:
•
the "Operating mode selector" page:
•
the status bar, by clicking on the status icon (beginning of §3.2.1.1).
