-16-
Fig. 16
To adjust the depth you will need:
5/32” Allen Hex Wrench
Piece of writing paper cut to approximately 1” x 4”
Two identical key blanks-measure blade width with micrometer or calipers and select two that match.
To begin the adjustment you must loosen the two #10-32 Screws. Use your 5/32” Allen Hex Wrench
to loosen the two screws about 1 turn each.
Before you begin please make sure that both top vise jaws are in the standard configuration. See figure 17
below.
Fig.17
Depth is adjusted by moving the stylus forward or backward by means of a knurled adjustment knob located
at the back of the stylus. The adjustment is secured by two #10-32 Allen Socket Head Cap Screws located
on the top of the stylus holder.
Depth Adjust-
Cutter Shaft Lock
Power Switch
TOP JAW STANDARD
CONFIGURATION
