Ryobi RY10519B, Руководство оператора

Страница: 29 / 120

Page 29 — English
LEFT HAND
CUTTERS
RIGHT HAND
CUTTERS
Fig. 52
MAINTENANCE

Lift the file away from the steel on each return
stroke.

Put a few firm strokes on every tooth. File all left
hand cutters in one direction. Then move to the
other side and file the right hand cutters in the
opposite direction.

Remove filings from the file with a wire brush.
NOTICE:
A dull or improperly sharpened chain can cause
excessive engine speed during cutting, which
may result in severe engine damage.
WARNING:
Improper chain sharpening increases the poten-
tial of kickback, which can result in serious
personal injury.
WARNING:
Failure to replace or repair a damaged chain
can cause serious injury.
WARNING:
The saw chain is very sharp, always wear pro-
tective gloves when performing maintenance
to the chain to prevent serious personal injury.
TOP PLATE FILING ANGLE
See Figure 53.

CORRECT 30° – file holders are marked with
guide marks to align file properly to produce
correct top plate angle.

LESS THAN 30° – for cross cutting.

MORE THAN 30° – feathered edge dulls quickly.
SIDE PLATE ANGLE
See Figure 54.

CORRECT 80° – Produced automatically if you
use the correct diameter file in the file holder.

HOOK – “Grabs” and dulls quickly; increases the
potential of KICKBACK. Results from using a file
with a diameter too small or a file held too low.
INCORRECT
MORE THAN 30°
TOP PLATE FILING ANGLE
LESS THAN 30°
Fig. 53
30°
CORRECT
INCORRECT
BACKWARD SLOPE
SIDE PLATE FILING ANGLE
Fig. 54
80°
CORRECT
HOOK

BACKWARD SLOPE – Needs too much feed
pressure; causes excessive wear to the bar and
chain. Results from using a file with a diameter
too large or file held too high.