RULES FOR SAFE OPERATION
3
I
Read all safety instructions before using
Read the owner's manual carefully. Learn its applica-
tions and limitations as well as the specific potential
hazards.
I
Ground all tools (unless double insulated)
If tool is equipped with an approved 3-conductor cord
and a 3-prong grounding type plug to fit the proper
grounding type receptacle, the green conductor in the
cord is the grounding wire. NEVER connect the green
wire to a live terminal.
I
Keep away from hazardous materials
Normal sparking of the motor could ignite fumes,
flammable liquids, or combustibles.
I
Protect yourself against personal injury
DO NOT operate any tool while under the influence of
drugs, alcohol, or any medication.
I
Dress for safety
Do not wear loose clothing, gloves, neckties, or jewelry,
as these items can get caught and draw you into
moving parts. ALWAYS wear non-slip footwear. Tie back
long hair. Roll long sleeves above the elbow.
I
Avoid accidental starting
Make sure all switches are in "OFF" position before
plugging in.
I
Never stand on tool
Serious injury could occur if the tool is tipped or if the
cutting tool is accidentally contacted. DO NOT store
materials above or near the tool, making it necessary to
stand on the tool to reach them.
I
Protect and use suitable cords
NEVER carry tool by cord or yank it to disconnect from
receptacle. Protect cord from heat, oil and sharp edges.
For outdoor operation, use extension cords intended for
outdoor use.
I
Avoid a dangerous environment
DO NOT use power tools in damp or wet locations or
expose them to rain. Keep work area well lit and
provide an adequate surrounding work space.
I
Check direction of feed
Feed workpiece against the router bit’s direction of
rotation.
WARNING:
WARNING:
Means that failure to follow this safety statement may
result in extensive product damage, serious personal
injury, or death.
I
Check damaged parts
Before further use of the tool, a guard or other part that
is damaged should be carefully checked to ensure that
it will operate properly and perform its intended
function. Check for alignment of moving parts, binding
of moving parts, broken parts, mounting and any other
conditions that may affect its operation. A guard or other
part that is damaged should be properly repaired or
replaced.
I
Never leave tool running unattended
Turn power off. Do not leave tool until it comes to a
complete stop.
I
Secure router table
DO NOT attempt to use your router table unless it is
fastened firmly to your workbench or floor.
I
Disconnect tools before servicing
When changing bits, make sure router is unplugged.
I
Keep guards in place
Be sure guards are in working order, properly adjusted,
and aligned.
I
KEEP HANDS AWAY FROM CUTTING AREA
