![background image](http://html1.mh-extra.com/html/ryobi/rt601w/rt601w_operators-manual_1505957024.webp)
OPERATION
24
Outside routing
See Figure 36
1. Place your workpiece on the tabletop relative to the
router bit.
2. Feed your workpiece through the bit in the direction of
the arrow. Always feed against the router bit’s direction
of rotation.
Fig. 35
Fig. 36
Inside routing
See Figure 35
1. Place your workpiece on the tabletop relative to the
router bit.
2. Feed your workpiece through the bit in the direction of
the arrow. Always feed against the router bit’s direction
of rotation.
Routing without safety shield, and/or fence
Some jobs require that you rotate the safety shield out of
the way and remove the fence.
Using the router without the safety shield and fences
in place can lead to serious personal injury. Use
extreme caution: Operate the router without safety
shields and fences ONLY when absolutely necessary,
and with ballbearing-guided-type router bits.
WARNING:
Fig. 37
Routing irregular workpieces
See Figure 37 and 38
1. Use the allen screw
(AH)
and thread into the hole as
shown in the detail. Use an allen key (size 5 mm) to
tighten the screw.
2. Position the workpiece against the allen screw, but
clear of the router bit. Turn on router and slowly
advance the workpiece toward the bit until it touches
the ball-bearing guide and the bit begins to cut wood.
Feed workpiece against the rotation of the bit.
AH (1)
AH