ASSEMBLY
11
TO ATTACH THE LEG SUPPORTS
See Figure 4
6. Attach each pair of leg supports
(E)
and
(F)
to
extension and table legs. Place each support as shown
below and fasten together using 12 pan head screws
(AD)
, 12 toothed washers
(AM)
and 12 hex nuts
(AP)
provided. Use a #2 Phillips screwdriver to keep from
stripping the screw heads.
7. Place the router table on its legs.
CAUTION:
Control the alignment of tabletop and the two
extenions by sliding miter bar
(K)
through miter guide
slot as shown below . If necessary loosen scews and
adjust alignment of tabletop and extensions.
Retighten screws
(AD)
as described in figure 2 on
side 10.
AD (12)
AM (12)
AP (12)
Fig. 4
AP
AM
AD
AM
AP
AD
F
E
E
F
K
MITER GUIDE SLOT
AP
AM
AD
