![Ryobi RHT25X60RO Скачать руководство пользователя страница 27](http://html1.mh-extra.com/html/ryobi/rht25x60ro/rht25x60ro_user-manual_1507115027.webp)
25
English (Original instructions)
TROUBLESHOOTING
If these solutions do not solve the problem, contact your authorised service dealer.
PROBLEM
POSSIBLE CAUSE
SOLUTION
Engine will not start.
No fuel.
Push primer bulb until bulb is full of fuel.
If bulb does not
fi
ll, primary fuel delivery
sys tem is blocked. Con tact a servicing
dealer. If prim er bulb
fi
lls, engine may be
fl
ooded, proceed to next item.
Engine is
fl
ooded.
Pull starter with choke lever at
position and wide open throttle. If engine
does not start, move choke lever to
position and repeat normal starting
procedure. If engine still fails to start,
repeat procedure with a new spark plug.
No
spark.
Check spark. Remove spark plug.
Reattach the spark plug cap and lay
spark plug on metal cylinder. Pull the
starter rope and watch for spark at spark
plug tip. If there is no spark, repeat test
with a new spark plug.
Starter rope pulls harder now than when
new.
Contact a servicing dealer.
Engine starts but will not ac cel er ate.
Engine requires approximately three
minutes to warm up.
Allow engine to completely warm up. If
engine does not accelerate after three
minutes, contact a ser vic ing dealer.
Engine starts but will only run at high
speed at half choke.
Carburetor requires adjustment.
Contact a ser vic ing dealer.
Engine does not reach full speed and
emits ex ces sive smoke.
Check lubricant fuel mixture.
Use fresh fuel and the correct 2-stroke
lubricant mix.
Air
fi
lter is dirty.
Clean air
fi
lter. Refer to Clean ing the Air
Filter earlier in this manual.
Spark arrestor screen is dirty.
Contact a servicing dealer.
Engine starts, runs, and accelerates but
will not idle.
Idle speed screw on carburetor requires
adjustment
Contact a servicing dealer.
NOTE:
If your product exhibits speci
fi
c performance problem(s) where the Troubleshooting section recommends a clockwise
screw adjustment on the carburetor and no adjustments have been made since original purchase, the product should be taken to
an authorised service centre for repair. In most cases, the needed adjustment is a simple task for the trained service representative.
Содержание RHT25X60RO
Страница 303: ......
Страница 328: ...Techtronic Industries GmbH Max Eyth Straße 10 71364 Winnenden Germany 960639029 01 ...