Ryobi RCS3845, Оригинальное руководство пользователя

Страница: 17 / 44

15
GETTING STARTED GETTING STARTED GETTING STARTED GETTING STARTED
1. Depress the trigger release.
2. Squeeze the throttle trigger.
3. Release the throttle trigger to return the engine to idle.
Allow the product to run idle for 15 - 30 seconds.
1. Depress the trigger release.
2. Squeeze the throttle trigger. Always hold the product with your right hand at the rear
handle and your left hand at the front handle. Grip both
handles with the thumbs and fingers encircling the handles.
Ensure that your left hand is holding the front handle so that
your thumb is underneath.
Always hold the product with both hands during operation.
Use a firm grip with thumbs and fingers encircling the
chainsaw handles. Right hand must be on the rear handle
and left hand on the front handle.
Disengage the chain brake. Push the choke lever to the half-choke position. Pull the starter grip until engine starts.
Disengage the chain brake. Make sure the bar mounting nuts are loosened to finger-
tight.
To increase the chain tension, turn the chain tensioning
screw clockwise and check the chain tension frequently.
To reduce the chain tension, turn the chain tensioning
screw counterclockwise and check the chain tension
frequently.
Tighten the bar mounting nuts by turning them clockwise
to 11 ~ 13 Nm (Turn the nut 180° or 3 flats past finger
tight). Do not overtighten.
Pre-mix unleaded petrol and 2-cycle engine lubricant in a
clean container approved for petrol.
1. Loosen the fuel cap by turning it counterclockwise.
2. Lift the fuel cap and set aside.
3. Carefully pour the fuel mixture into the tank. Avoid
spillage. Prior to replacing the fuel cap, clean and
inspect the gasket. Immediately replace the fuel cap
and hand tighten it. Wipe away any fuel spillage.
1. Loosen the oil tank cap by turning it counterclockwise.
2. Lift the oil tank cap and set aside.
3. Pour the oil into the oil tank and monitor the oil level
gauge. Ensure that no dirt enters the oil tank while
filling. Put the oil tank cap back on and tighten. Wipe
away any spillage.
NOTE: It is recommended that the air filter be lubricated with several
drops of chain and bar oil before first use. Refer to page 32.
1. Engage the chain brake by pushing the front hand
guard/chain brake forward.
4 3
14 13
2
1
5
2
1
6
2
1
3
15 16
(50 : 1)
7
2
3
8
2
1
17
2
3
9 10