Ryobi RCS3845, Оригинальное руководство пользователя

Страница: 11 / 44

9
WHAT’S IN THE BOX
RCS3845
■ Chainsaw x1
■ Guide bar cover x1
■ Combination wrench x1
■ Operator’s manual x1
■ Engine oil (76 ml) x1
■ Chain and bar oil (76 ml) x1
SYMBOLS ON THE PRODUCT
Safety alert
To reduce the risk of injury, user must
read and understand operator’s manual
before using this product.
Regulatory Compliance Mark (RCM).
Product meets applicable regulatory
requirements.
Wear eye, hearing and head protection
when operating this equipment.
Wear non-slip safety footwear when
using the product.
Wear non-slip, heavy-duty protective
gloves when handling the chainsaw.
Danger! Beware of kickback.
Hold and operate the saw properly with
both hands.
Do not operate the saw using only one
hand.
Use unleaded petrol intended for motor
vehicle use with an octane rating of 91
([R+M]/2) or higher.
Use 2-stroke oil for air cooled engines.
Mix the fuel mix thoroughly and also
each time before refueling.
Add bar and chain oil every time you
add fuel to the chainsaw.
Mix fuel outdoors where there are no
sparks or flames.
Do not smoke when mixing fuel or filling
fuel tank.
The guaranteed sound power level is
115 dB
Run position
Half-choke position
Full-choke position
Set the chain brake to the "run"
position.
Set the chain brake to the "brake"
position.
Set the chain brake to the "run"
position.
Set the chain brake to the "brake"
position.
Fully press and release the primer bulb
at least 10 times.
Pull the choke lever all the way out to
the "full-choke" position.
Pull the starter grip until the engine
attempts to start (no more than five
times).
Set the choke lever to the "half-choke"
position.
Pull starter grip until the engine starts
(no more than five times).
Depress the trigger release and
squeeze the throttle trigger, then
release the throttle trigger to return the
engine to idle.
Allow the product to run idle for 15 - 30
seconds.
Bar and chain lubricant
Chain lubricant pump flow
+ = Increase flow
- = Decrease flow
PLACEHOLDER