0
MAINTENANCE
Fig.
Fig.
SPOOL
RETAInER
STRInG
HEAd
dRIVE SHAfT
Fig. 5
ALIGn
LInE On
knOB wITH
ARROwS
InSERT
STRInG TO
cEnTER
And ROTATE
knOB TO
wInd
EyELET
INSTALLING STRING IN REEL EASY LINE
HEAD
See Figures 23 - 24.
Use 2.4mm diameter monofi lament string.
n
Stop the engine and disconnect the spark plug wire.
n
Cut one piece of string approximately 7.6m in length.
n
Rotate knob on string head until line on knob aligns
with arrows on top of string head.
n
Insert one end of string into eyelet located on the side
of the string head and push until string comes out
through eyelet on the other side. Continue to push
string through the string head until the middle section
of the string is inside the string head and string outside
the string head is evenly divided on each side.
n
Rotate the knob on the string head (clockwise for
RBC0SESA and counterclockwise for RLT0CESA)
to wind the string.
n
Wind the string until approximately 0cm remains
protruding from the string head.
INSTALLING PRO CUT II STRING HEAD
See Figure 25.
n
Stop the engine and disconnect the spark plug wire.
n
Remove currently installed string head.
n
Install the string head on the drive shaft until fully
seated.
n
Install string.
