10
ASSEMBLY
INSTALLING THE POWER HEAD TO THE
ATTACHMENT
See Figure 2.
WARNING
Never install, remove, or adjust any attachment
while power head is running. Failure to stop the
engine can cause serious personal injury.
The attachment connects to the power head by means of
a coupler device.
n
Loosen the knob on the coupler of the power head shaft
and remove the end cap from the attachment.
n
Push in the button located on the attachment shaft.
Align the button with the guide recess on the power
head coupler and slide the two shafts together. Rotate
the attachment shaft until the button locks into the
positioning hole.
NOTE:
If the button does not release completely in the
positioning hole, the shafts are not locked into place.
Slightly rotate from side to side until the button is locked
into place.
n
Tighten the knob securely.
WARNING
Be certain the knob is fully tightened before
operating equipment; check it periodically for
tightness during use to avoid serious personal
injury.
REMOVING THE ATTACHMENT FROM THE
POWER HEAD
For removing or changing the attachment:
n
Loosen the knob.
n
Push in the button and twist the shafts to remove and
separate ends.
ATTACHING THE STORAGE HANGER
See Figure 3.
There are two ways to hang your attachment for storage.
n
To use the hanger cap, push in the button and place
the hanger cap over end of the lower end attachment
shaft. Slightly rotate the cap from side to side until the
button locks into place.
n
The secondary hole in the attachment shaft can be
used for hanging purposes as well.
Fig.
cOuPLER
knOB
TRIMMER ATTAcHMEnT
POwER HEAd
SHAfT
POSITIOnInG
HOLE
GuIdE
REcESS
Fig.
BuTTOn
HOLE
HAnGER
cAP
SEcOndARy
HOLE
BuTTOn
