11
ASSEMBLY
ATTACHING THE FRONT HANDLE
See Figure 4.
Follow these steps to attach the front handle.
n
Remove the slotted Torx screws to separate the handle
from the handle support.
n
Press the handle onto the top of the upper shaft, no
less than 165mm from the edge of the trigger handle,
angling the handle toward the trigger handle.
n
Place the handle along the upper shaft to a position
that allows for comfortable operation.
n
Place the handle support on the bottom of the tube on
the opposite side of the front handle.
n
Secure the handle with the slotted Torx screws.
ATTACHING THE GRASS DEFLECTOR
WARNING
The line cutting blade on the grass deflector
is sharp. Avoid contact with the blade. Failure
to avoid contact can result in serious personal
injury.
TO ATTACH THE CURVED SHAFT GRASS
DEFLECTOR
See Figure 5.
(RLT30CESA)
n
Remove hex screw, flat washer, and wing nut from
grass deflector.
n
Press the grass deflector onto the bottom of the curved
shaft as shown.
n
Insert the hex screw through the grass deflector and
the bracket on the curved shaft.
n
Place the flat washer on the hex screw.
n
Place the wing nut on the hex screw and tighten
securely.
TO ATTACH THE BRUSH CUTTER GUARD
See Figure 6.
(RBC30SESA)
n
Attach the blade guard to the mounting bracket; install
the four screws from the top of the mounting bracket
through the blade guard and into the threaded mounting
plates.
n
Using the torx wrench supplied, tighten all four screws
securely.
NOTE:
When using the string head, the grass deflector
must be attached to the blade guard.
Fig.
Fig. 5
Fig. 6
MOunTInG
BRAckET
BLAdE
GuARd
nOTcH
MOunTInG
PLATES
LOckInG
TAB
GRASS
dEfLEcTOR
