5
WARNING
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
could result in serious personal injury.
Ŷ
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Ŷ
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
Packing list
– Nailer
– Wrench kit
– Air tool oil
– Moulded carry case
– M8 screw hanger
– Operator’s manual
WARNING
If any parts are damaged or missing do not operate
this tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such
DOWHUDWLRQ RU PRGL¿FDWLRQ LV PLVXVH DQG FRXOG UHVXOW
in a hazardous condition leading to possible serious
personal injury.
OPERATION
WARNING
Do not use oxygen, combustible gases or bottled gases
as a power source for this tool. The tool will explode and
cause death or serious injury.
WARNING
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
VXI¿FLHQWWRLQÀLFWVHYHUHLQMXU\
WARNING
Always wear safety goggles or safety glasses with side
shields when operating tools. Failure to do so could
result in objects being thrown into your eyes resulting
in possible serious injury.
WARNING
Disconnect the tool from the air supply before leaving
the work area, moving the tool to another location, or
handing the tool to another person. Failure to do so
could result in serious personal injury.
WARNING
Always wear eye protection. Eye protection does
QRW ¿W DOO RSHUDWRUV LQ WKH VDPH ZD\ 0DNH VXUH WKH
eye protection chosen has side shields or provides
SURWHFWLRQ IURP À\LQJ GHEULV ERWK IURP WKH IURQW DQG
sides.
PREPARING THE TOOL FOR USE
6HH¿JXUH
WARNING
Please read and observe these operating instructions
before using the tool. Basic safety measures should
always be strictly followed to protect against damage to
the equipment and personal injury to the user or other
people working in the vicinity of operation.
Under normal use conditions, the tool should be lubricated
with air tool oil before connecting the tool to an air supply.
$GG DLU WRRO OXEULFDQW LQWR WKH DLU ¿WWLQJ RQ WKH WRRO RQFH
daily with minimal use, or twice a day with heavy use. Only
a few drops of oil at a time is necessary. Too much oil will
only collect inside the tool and will be noticeable in the
exhaust cycle.
Before connecting the tool, check the air compressor
gauge to be sure it is functioning within the proper range
of 5.5 - 8.3 bar (80 - 120 psi).
ADJUSTING THE EXHAUST
6HH¿JXUH
The adjustable exhaust on the end cap of the tool allows
the operator to direct the exhaust according to operator
preference.
To adjust, turn the exhaust cap in the desired direction.
CONNECTING THE TOOL TO AN AIR SUPPLY
6HH¿JXUH
