![background image](http://html.mh-extra.com/html/ryobi/airgrip-ez-reach-elb001/airgrip-ez-reach-elb001_operators-manual_1505709011.webp)
11
OUT
IN
GRIP/REL
GR
IP/
RE
L
WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating tools. Failure to do so could re-
sult in objects being thrown into your eyes, resulting in
possible serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this tool. The use of at-
tachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
Removing/installing light bulbs
WARNING:
Battery tools are always in operating condition. There-
fore, switch should always be locked when not in use or
carrying at your side.
WARNING:
Do not use EZ Reach on free hanging light fixtures. Only
use on light sockets and fixtures that are fixed in place.
The EZ Reach system can be used with or without an ex-
tension pole. To use without an extension pole, follow all
Assembly
instructions for the EZ Reach system, but do not
attach the stick driver to a pole.
REMOVING/INSTALLING LIGHT BULB
See Figures 8 - 11.
Push the power button on the stick driver to turn on the
driver. The green activation light should light up.
Slide the ON/OFF switch on the AIRgrip system to the
ON
( I )
position. The AIRgrip system will briefly vibrate
when turned on.
NOTE:
The power light on the AIRgrip system should be
green. When the battery in the AIRgrip system is low, the
power light will change from green to red. Change the bat-
tery immediately. Refer to
Changing the Batteries
later in
this manual.
OPERATION
Fig. 8
Fig. 9
Fig. 10
POWER BUTTON
ON/OFF
SWITCH
POWER LIGHT
GRIP/
REL
LIGHT
BULB
SUCTION HEAD