•
Operation Guide
Part 1
– How to Load and Light your Melter
1. Ensure your regulator is off by rotating regulator knob fully counter-clockwise (rotate left).
2. Slowly pressurize the regulator by rotating the valve located on the propane cylinder counter-clockwise all
the way (rotate left).
3. Inspect and ensure there are no leaks between any of the connections before proceeding.
4. Load crack sealant into kettle, while ensuring sealant is resting on the bottom of the kettle.
5. Remove the torch from the kettle and make sure the valve on the torch handle is fully OPEN by turning it
COUNTERCLOCKWISE.
6. Slowly turn the regulator knob a few times CLOCKWISE so that the propane starts to flow.
7. Use a striker or long BBQ lighter to light the torch.
8. Adjust the flame by adjusting the fuel pressure on the regulator and return the torch to the torch holder.
⚠
Operating the torch on high in most conditions is not recommended and this can easily overheat the
material.
⚠
Never exceed the manufacturer's recommended material maximum temperature.
Содержание RA-MLT-0015
