RynoWorx RA-MLT-0015, Руководство оператора

Страница: 27 / 27

•
Troubleshooting Guide
Below we have provided a common problems and solutions table. Be sure to consult this table should you
experience any technical problems.
Description of Problem Possible Causes Known Solutions
The torch will not ignite or
the torch will not stay lit 1) The fuel level could be too low
2) The propane cylinder valve
could be partially or fully closed,
which can restrict fuel flow 3) The
pressure regulator valve may be in
the off position or may not be
providing sufficient fuel flow 1) Check and refill your fuel tank
2) Ensure your fuel valve is fully
open. You can do this by turning
the knob fully counter-clockwise 3)
You may increase the pressure
from the regulator by turning the
knob clockwise
Torch will not stay lit 1) The fuel level may be too
low 2) The fuel tank valve or
torch valve may not be fully
open and therefore restricting
fuel flow, or your regulator may
not be providing enough
pressure
3) The wind may be blowing out
the flame. 1) Refill your fuel tank
2) Ensure your fuel tank valve
and torch valves are fully open
and use your regulator to
increase or decrease flame
strength
3) Move equipment to a less
windy area or try turning
equipment so that the torch is not
facing the wind
Crack filler is melting really slowly 1) Incorrect crack sealant being
used
2) Torch is not providing enough
heat to melt the crack sealant
3) The temperature outside is
cooler than normal slowing down
the melting process
4) The wind is continuously
blowing out your flame, not
allowing your machine to build
heat quickly 1) Double check that your using
an approved crack sealant for use
in direct-fire melters
2) Increase the fuel to your torch
3) No solutions, melting takes
longer on cooler days
4) Move equipment to a less
windy area or try turning
equipment so that the torch is not
exposed to the wind