ryan LAWNAIRE 28 544874F, Руководство оператора

Страница: 12 / 26

10
Lawnaire
28
SET-UP
9. Push the latch lever (on the handle) to raise and
lower the unit. If the latch drops into the notch
easily, when raised and lowered, proceed to step
10. Remove hairpin cotter
I from rod G . Pull rod
from Pivot Shaft and adjust by turning rod so
that the latch drops into the notch easily when
the unit is lowered. Operating the clutch lever
with the unit lowered, will allow the rod to be
removed for adjustment.
10. Operate the clutch lever to check for positive belt
engagement. If belt needs adjustment, refer to
Drive Belt Adjustment (page 17).
11. Reisntall the handle cover assembly. Route the
throttle cable as shown, under the handlebar
support
1 . Route the throttle cable through the
clip 2 , and then over the handle bar tube. (Note:
For ease of cover assembly, the throttle control
cable can be removed, then reinstalled.)
12. Install the engine on/off switch 3 . Cut the plastic
tie holding the wire harness. Route the wire
harness along the handlebar tube
4 . Connect
the harness to the switch 5 . The notch in
the connector goes on the terminal with the
formed detent. Secure the wire harness to the
handlebars with two plastic ties
6 .