ryan LAWNAIRE 28 544874F, Руководство оператора, Страница: 13 / 26

11
Lawnaire
28
13. HONDA THROTTLE HOOK-UP:
(See step 14 for Briggs throttle hookup.)
-Remove the air cleaner.
-Using a 10mmm socket or wrench, slightly
loosen the engine throttle pivot nut
7 , 1/8 of a
turn. (this is approximate, adjust as required for
proper throttle control feel.)
-Attach the throttle cable as shown, with the
"Z-bend" end put into the hole
8 in the carburetor
lever.
-Remove the cable clamp
9 on the engine.
-Route the cable under the clamp, and replace
the cable clamp leaving it loose.
-Move the throttle control lever on the handle to
the fast position, then pull back about 1/8".
-On the engine, move the throttle lever
10 to the
fully fast position (far left).
-Tighten cable clamp
9 .
14. BRIGGS THROTTLE HOOK-UP:
-Remove the cable clamp on the engine 11 .
-Insert the "Z-bend" end of the throttle cable into
the hole
12 on the throttle arm
-Reinstall the cable clamp leaving it loose with
the cable below the mounting screw.
-Move the throttle control lever on teh handle to
the "FAST" position, then pull back about 1/8".
-On the eninge, move the throttle lever to the fully
fast position (far right).
-Tighten the cable clamp screw.
15. Check the engine oil level (best when done with
the machine lowered to the aerating position.)
16. Raise the machine to the transport position and
add fuel and start the engine. (Refer to Controls
on P. 12 if necessary)
17. Check for full range of throttle movement, and
adjust cable position 9 or 11 if necessary.
18. Stop the engine using the key switch, and
replace the air cleaner on Honda engines.
19. Reinstall the hood.
SET-UP