RVsecure Protector Operating Manual
Key
Press
Description
A
Press 1x
System will arm
B
Press 1x
No Action
C
Press 1x
Change of motion sensitivity
D
Press 1x
System will disarm, all strobes / sirens off
and reset
D
Press 3x within 10 seconds
when alarm off
Programming mode for adding sensors
Sensors included
ProtectorX Caravan
RVS_CW2
1x PIR
1x Reed
ProtectorX Camper
RVS_CW1
2x Reed
All
On board Motion Sensor
Arming the system
When key “A” is pressed to turn the alarm on the control system reads the system sensors. If the sensors are OK then
the system will arm, there will be a short strobe flash for 1 second and a short audible beep from the control unit to
indicate that the system is armed.
If a sensor is not OK then the system will not arm. A long strobe flash and long audible beep from the control unit (2
seconds) will indicate the failure to arm. The user can then rectify the situation and try again.
Arming
Normal Mode
Pressing “A” arms the system in normal mode with both the sensors (PIR/Reed Switches) and Movement sensors
active. Any activation in this mode will activate the strobe and sound the siren.
Disarming the System
Pressing “D” will disarm the system.
Key features of Operation when in Alarm
Siren
•
When alarm activated the siren will sound for 15 seconds then reset. If activated again, siren will sound for
another 15 seconds then reset. There is a maximum of 3x siren activation's then the siren will not resound.
When the alarm is disarmed and rearmed the number of activation's will reset again.
Strobe
•
When alarm activated the strobe will run for 35 seconds, it has a rolling sequence that will change every 5
seconds. After 35 seconds it will go into power save mode, this will mean it is on for 1 second and off for 3
seconds. When the alarm is disarmed the strobe power save will reset.
Anti-Tow
•
The Anti-Tow system will only activate on the movement sensor and not the PIR. When activated (between 1
and 5 seconds after sensing initial vehicle movement) the brakes will lock for 10 seconds. Each time after this
that the movement sensor is activated the brakes will lock for another 10 seconds. Multiple activation’s can
occur sequentially.
Please note: Installation of the braking relays and braking circuit is optional and not required for the correct
rvsecure.com.au
Made in Australia
