operation of the alarm system.
Anti-Hitch
•
The Anti-Hitch sensing operates when the system detects an attempt to hitch the vehicle. It reacts in the same
way as the Anti-Tow sensing by activating the alarm and brakes.
Adding additional sensors to the system
1. Press “D” 3x to enter programming mode
2. Press “A” to add a sensor
3. Activate the sensor for the control unit to register, it will beep to confirm added. If the sensor is already in the system
a long beep will be heard to notify you of this.
4. If another sensor required, repeat step 2/3
5. When finished press “D” to exit
6. If you have forgotten to exit, system will time out and exit programming mode automatically
Wired Sensors (optional)
Wired sensors (PIN switches) can be added to the system. All wired sensors must be N.O type and multiple sensors can
be wired in parallel. Connect as per installation instructions. If the sensor is closed (activated) when arming the alarm
it will not arm and provides a long beep warning that the system is not ready. Check any wired sensor and rearm.
Changing motion sensitivity
The motion sensitivity has 5 settings, 1 (low) to 5 (high), the unit comes initially set to 3 - Mid. There are many factors
that can effect the required sensitivity. Vehicle weight, weight distribution, suspension type and position, tyre type and
pressure, caravan legs up/down as well as many environmental factors including road surface, wind and other
conditions. The mounting position of the alarm control unit is also a factor that has an effect on operation.
Press “C” to change. System beeps once if high sensitivity through to 5 times for low sensitivity
Whilst every vehicle is different, the following is a guide on the starting point for the sensitivity settings.
Tow and door direction
The tow and door directions need to be set depending on the mounting orientation of the unit as this allows the
movement sensing to operate correctly. There are six options, 1 to 6. For tow direction choose the option
corresponding to the diagram below where the side chosen is facing the front of the vehicle. Ie if 2 is facing the front,
select 2 (3 is the front and 6 is the rear of the Control unit). The door direction is the side of the vehicle with the entry
door (ie passenger/kerb side of those without a door).
Tow Direction
1. Press “D” 3x to enter programming mode
2. Press “B” to change. System beeps
corresponding to the numbers shown.
3. Press “B” to change again or “D” to exit
Door Direction
rvsecure.com.au
Made in Australia
