Assembly
To be able to fully assemble the commode chair, position the body frame in front of you and lock the braking castors,
so that the commode chair cannot roll away during assembly.
Mounting the back and armrests
1.
Remove the backrest from the packaging. Insert the rod ends of the backrest into
the rod ends of the body frame until they lock into place. Ensure that the inside of
the backrest points towards the centre of the chair.
2.
Turn the two setting screws on the rear of the chair clockwise and tighten.
3.
The armrests should lock into place themselves if you swivel them upwards in one
short movement.
Mounting the footrests
Insert the footrest bars into the mounting pins intended for this on the main frame. Swivel the footrest bars towards the
centre. The locking mechanism automatically snaps into place. You can now fold down the foot plates. Finally attach the
calf strap to its holder on the footrest bar.
Setting the footrest height
For this you require an open-ended or ring spanner SW10.
Set the height of the footrests so that your thigh is horizontal if you have your feet on the
footrests while sitting.
1.
Loosen the locking screw on the footrest rod.
2.
Push the footrest to the required height. The rod may not be pulled out beyond the
rod marking! Tighten the locking screw again.
Assembling the seat and commode bucket
1.
Take the white seat and place it onto the main frame from above. Ensure that
the seat plate is aligned correctly: The closed, round edge of the seat should
point forwards, the commode bucket guide on the seat underside should point
to the rear.
2.
You can push the commode bucket into the guide from the rear below the seat
face, with or without its lid.
Finally you can place the padded seat cover on the toilet seat to increase comfort
when sitting normally.
Backrest
Pushing handle
Swivelling
armrest
Adjusting screw
Snap
Braking castor
Castor
Swivelling, height-
adjustable leg
support and footrest
Seat cushion
Toilet seat
Calf strap
Commode
chair bucket
3
1
1
1
1
1
2
1
1
2
2
