12
Pre-Installation
Important Note: Prior to installation and first use the following 4 steps must be followed,
failure to do so will void your guarantee:
1. Set the water softener level
2. Add 1.5kg dishwasher salt and fill the salt container with water
3. Add rinse aid to the rinse aid dispenser
4. Fill the detergent dispenser with detergent powder or a detergent tablet
Water Hardness & Setting the Salt
The water softener must be set digitally, using the water hardness setting function. The
water softener is designed to remove minerals and salts from the water, which would have
a detrimental or adverse effect on the operation of the appliance. The higher the content
of these minerals and salts, the harder your water is. The softener should be adjusted
according to the hardness of the water in your area. Your local Water Authority can advise
you on the hardnessof the water in your area.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjustment in the amount of sa lt co nsumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
Please follow the steps below for adjustment in salt level/consumption:
1. Open the door and switch on the appliance.
2.
Within 60 seconds after the appliance was switched on press and hold the ‘Program’ button
for more than 5 seconds to start the water softener setting function. The salt warning light
will flash periodically during the water setting function. The unit will exit the salt setting
function if no button is pressed within 5 seconds.
3.
Press the ‘Program’ button to select the required softener level in accordance with your local
water hardness level. The program indicator lights will light up to indicator the different
softener levels (please see the table on the following page). The softener levels will change
in the following sequence: H1->H2->H3->H4->H5->H6 (H1 is the lowest setting and H6 is the
highest setting).
4. Press the On/off button to set the softener level.
