3 Next remove the pre filter and HEPA filters by pulling on the plastic frame
surrounding the HEPA. (The pre filter is attached to this frame also).
Behind this you will see the activated carbon filter which is packed in a plastic
bag for freshness. Remove the bag and replace the filter in the main body.
To replace the HEPA filter frame tilt the frame with the top side away from you and
put the top part into place in the main body. There are two plastic tags within the
top of the main body to help locate the frame in position. Once the top of the filter
frame is behind these tabs push the base of the filter frame into position. Replace the
front panel by locating the tabs at the top of the front panel into the main body.
Then snap the base of the front panel into the front panel removal clips. You will hear
it click into position. The machine will not function if the filter frame or front panel is
not positioned correctly as a safety feature.
4 Ensure none of the air intakes or outlets are blocked.
positioning
5 Sit the air purifier on a dry, stable, level surface, near a power socket.
6 For best results the air purifier should be placed on an elevated surface, around
50cm from the floor. The air purifier can also be placed directly on the floor.
7 Route the cable so it doesn’t overhang, and can’t be tripped over or caught.
8 Put the plug into the power socket (switch the socket on, if it’s switchable).
LCD display panel
Your air purifier has many functions and the LCD panel displays the ambient air
quality reading, the time, the mode selected.
When any buttons are pressed on the control panel or remote control the LCD lights
up in a blue colour. Thirty seconds after pressing the last button, the blue light fades.
The LCD will also beep once to indicate that a button has been pressed. If it beeps
twice then it means the button you are pressing is not able to perform any function.
setting the clock
As soon as you plug the air purifier into the mains socket you will hear a beep and
notice the display reads . You should set the time at this stage if you would like
to use the programmable on/off timer later.
Whilst still in standby mode to set the time, press the button. You will notice the
hours part of the time starts flashing and the word
time
appears on the display. Use
the and buttons to set the hour correctly. Please note this clock works on a
24 hour basis. Press the button again and you will notice the minutes part of the
display starts flashing. Again use the and buttons to set the time and
press again to confirm.
6
Fan Speed
Air Quality
Purify Air Refresh Timer On/Off Auto
Check Filter
A
UV1 UV2 UV3
1
2
3
4
SET
TIMER +
TIMER -
SET
TIMER +
TIMER -
SET
ountain
BREEZE
C L E A N A I R
