3
INTRODUCTION
This extractor has been designed and manufactured for professional applications, and it should be used for
these purposes. The extractor is designed for the extraction of dry dust only.
WARNING!
Never allow the extractor to suck in flammable substances, explosives, solvents, welding vapours, burning
substances, fuels, lubricating oils, alcohols, paints, or thinners. The collecting of dust from surfaces subject
to grinding, or coated with paint, which has not completed its catalytic cycle yet, may result in spontaneous
ignition, thus creating a serious risk of fire and/or explosion.
At a minimum of once a year the manufacturer or authorised personnel should inspect the system. NTS Sp.
z o.o. [Ltd.] will not be held responsible for any damage, direct or indirect, due to failure to follow the
guidelines provided in these Instructions.
INTRODUCTORY NOTES, MINIMUM REQUIREMENTS REGARDING POWER SUPPLY,
RATING PLATE
The machine in question has been designed and manufactured in compliance with safety rules, and
therefore it has been permitted for use as it constitutes no hazard for its users.
However, the following aspects need to be remembered:
-
the machine is earthed (only S135E) and has to be connected to a proper supply network;
-
do not exceed the maximum loads specified in the Specifications table;
-
the machine shall be used by properly trained personnel.
MINIMUM POWER SUPPLY REQUIREMENTS
-
monophase voltage 230 V - 50 Hz; with earth conductor 1.5mm
2
(only for S135E);
-
automatic overload switch 6Ka 30mA 16A has to be installed before supply circuit.
RATING PLATE
-
The rating plate in the back panel of the device provides general information. If you need to find
more detailed data, read “Specifications” section.
