31
NOTE: You must have an unlocked channel present to use Auto Setup.
Channel
Press Channel to select a specific source setup
(channel)
defined and stored in projector
memory. Once you enter a 2-digit channel number (or, if there is a list displayed, highlight it
and press ), the display will automatically change and update according to the numerous
setup parameters defined for that channel. Note that a new channel is automatically
created if you adjust an image from a new source.
NOTE: Channel ( Channel ) key behavior during a presentation depends on whether or
not the
Display Channel List
option is enabled in the
Menu Preferences
menu. You
can choose to use a scrollable list of channels when you press Channel, or you may
prefer to enter the desired channel number “blind”, i.e., without on-screen feedback. See
Menu Preferences
later in this section.
Input 1
Press Input 1 to display from the data or video input source connected to BNCs labeled
INPUT 1
.
Input 2
Press Input 2 to display from the DVI source connected to
INPUT 2
.
Input 3
Press Input 3 to display from the composite video source connected to
INPUT 3.
Input 4
Press Input 4 to display from the S-video source connected to
INPUT 4.
Input 5
Press Input 5 to display from the
INPUT 5
interface module installed in the Option 1
slot.
NOTE: If you have the optional
Dual SD/HD-SDI
Module installed and there are two
inputs connected here, the second input (B) is considered
INPUT 7
. If you are using the
built-in keypad or the remote keypad, press
INPUT 5
to access
INPUT 7
as follows:
• While displaying from
INPUT 5
, press Input 5 again. This switches to
INPUT 7
.
• While displaying from any input
other
than the Dual SD/HD-SDI Module, press Input 5 .
This switches to either
INPUT 5
or
INPUT 7
, depending on which of the
Dual SD/HD-
SDI Module
inputs (A or B) was last used. Press Input 5 again to display from the other
Dual SD/HD-SDI Module
input.
What an “Auto Setup” Does
OPTIMIZES:
SETS TO DEFAULT:
Pixel Tracking
Contrast
Pixel Phase
Brightness
Size and Blanking
Auto Input Level (off)
Vertical Stretch
Detail
(if video source)
Position
Filter
Input Levels
Luma Delay
Table 3.1 Auto Setup
Section 3: Operation
Section 3: Operation