Runco Signature Cinema SC-1, Руководство по эксплуатации для владельца

Страница: 94 / 126

Operation
82 Runco SC-1 Owner’s Operating Manual
PRE
L
IMINAR
Y
Service Use the Service menu to access advanced projector configuration settings. Thi s menu
s hould be u s ed by I S F-certified technician s only.
Te s t Video: Select Test Video from the Service Menu to access the internal test patterns
on the SC-1. Four patterns are available, consisting of white/gray or colored bars.
Press MENU to exit test pattern mode.
Input Name s : You can give each DHD Controller input a descriptive name. For example,
you may want to change the default input name to the type of source component
connected to it: “VCR,” “DVD,” “Laptop” et cetera. Composite, S-Video and Component
SD input names can be up to 12 characters long; the others can be up to eight characters
long.
To edit an input name, select Input Names from the Service menu. Press or to select
an input and press ENTER . Use the or buttons to change a character; press or
to select a character to change. When you have finished editing the input name, press
MENU .
To restore the default input name, press repeatedly to highlight that input name in the
“Restore” column. Then, press ENTER .
To save input names so that they can be restored after a System Reset (described on
page 85), press
repeatedly to highlight “Save.” Then, press ENTER .
Remote Control: The Remote Control menu shows you the primary and secondary
infrared (IR) codes to which the DHD Controller will respond. By default, both are set to
17. You can change these codes if either:
• Another device in the theater (a DVD player, for example) is responding to commands
from the DHD Controller remote control (Figure 2-6) in ways that are unpredictable or
undesirable.
• You have multiple DHD Controllers and want to control them independently, as
opposed to broadcasting commands from a single remote to all of them. In this
scenario, you can use multiple remotes programmed to use different IR codes. Or, you
can use a single remote and change the IR code as needed to address a specific
device.
S ervice
Te s t Video
Input Name s
Remote Control
Analog Out Mode
Di s play Device
HD Format
Trigger s
Mi s cellaneou s
Re s olution
S y s tem Re s et
Re s tore S aved S etting s
➤
You must enter a passcode to access the Service menu.
Note
Input Name s
Re s tore
Compo s ite Compo s ite
S -Video 1 S -Video 1
S -Video 2 S -Video 2
Component S D Component S D
HD/R G B 1 HD/R G B 1
HD/R G B 2 HD/R G B 2
HDMI 1 HDMI 1
HDMI 2 HDMI 2
S ave
The button takes you from top to bottom in the left column, then
from top to bottom in the right column. To highlight “Save,” scroll
through both columns.
Note