Runco Signature Cinema SC-1, Руководство по эксплуатации для владельца

Страница: 113 / 126

Runco SC-1 Owner’s Operating Manual 101
PRE
L
IMINAR
Y
6.1
RS-232 Connection
and Port Configuration To interface the DHD Controller with a home theater automation/control system or a PC
running terminal emulation software, connect it to your control system or PC as shown in
Figure 3-18.
Configure the RS-232 controller or PC serial port as follows: no parity, 8 data bits, 1 stop
bit and no flow control. Set the baud rate to 19200, to match that of the DHD Controller
RS-232 port.
6.2
Serial Command
Syntax Serial commands to the DHD Controller take the following form:
• Commands are not case-sensitive.
• For a single command that takes no parameters, type the command followed by a
carriage return; for example, to set the aspect ratio to Letterbox, type
LETTERBOX <Enter>
.
• For a single command that takes a parameter, type the command, a space or a
comma and the desired value followed by a carriage return; for example, to set the
brightness to -10, type
BRIGHTNESS -10 <Enter>
or
BRIGHTNESS , -10 <Enter>
.
• You can also send a string of multiple commands on a single line, separated by
commas. For example,
COMPOSITE,BRIGHTNESS 100,ANAMORPHIC <Enter>
switches to the Composite video input, sets the brightness to 100 and sets the aspect
ratio to Anamorphic. Command strings can be up to 255 characters long.
6. S erial Communication s
Avoid combining the
ON
or
POWER 1
commands with other commands
on a single line. After sending
ON
or
POWER 1,
allow at least five (5)
seconds for the DHD Controller to power up. If you have enabled the
ISF splash screen (refer to
Splash Configure on page 81), allow 15
seconds for the DHD Controller to power up.
Once it does, it will accept and properly execute multiple serial
commands.
Note