Runco Reflection CL-410, Руководство по эксплуатации для владельца

Страница: 52 / 57

52
Appendix: RS-232 Information
RS-232
Pin Configuration:
Pin 2: TxD
Pin 3: RxD
Pin 5: Ground
Communication:
Baud Rate: 9600
Bits: 8
Parity: None
Stop bits: 1
All commands are in ASCII format.
When the projector receives a valid code, it will reply with the first three letters of the
command followed by OK (example: If code RRA00 is sent, the projector will reply with
RRAOK). If the projector receives a non-valid command, no reply will be sent.
COMMAND DESCRIPTION REPLY
RRA00 Saves current settings to the CUSTOM 1 memory* RRAOK
RRA01 Saves current settings to the ISF Day memory* RRAOK
RRA02 Saves current settings to the ISF Night memory* RRAOK
RRB00 Recalls the Custom 1 memory settings RRBOK
RRB01 Recalls the ISF Day memory settings RRBOK
RRB02 Recalls the ISF Night settings RRBOK
RRC00 Selects the S-VIDEO input RRCOK
RRC01 Selects the COMPOSITE VIDEO input RRCOK
RRC02 Selects the COMPONENT 1 input RRCOK
RRC03 Selects the COMPONENT 2 input RRCOK
RRC04 Selects the DVI input RRCOK
RRC05 Selects the RGB input RRCOK
RRD00 Selects the ANAMORPHIC (16:9) aspect ratio RRDOK
RRD01 Selects the STANDARD (4:3) aspect ratio RRDOK
RRD02 Selects the LETTERBOX aspect ratio RRDOK
RRD03 Selects the VIRTUALWIDE aspect ratio RRDOK
RRD04 Selects the CINEMA (2.35:1) aspect ratio RRDOK
RRD05 Selects the VIRTUAL CINEMA aspect ratio RRDOK
RRE00 Turns the projector OFF RREOK
PON Turns the projector ON Random**
*Note: All image quality settings must be made with the remote control. Once the
image adjustments are complete, these commands will allow the settings to be stored
in the selected memory.
**Note: The power on command (PON) will not provide an OK reply, it will instead
reply with a random character. For your automation system, simply ensure that you
receive a character after the PON command. If you do not get any reply after PON,
send PON again.